材料期刊网

CHARACTERISTICS OF INTERNAL FRICTION AND MODULUS ASSOCIATED WITH NON-EQUILIBRIUM DIFFUSION-TYPE PHASE TRANSFORMATION IN EUTECTOID Al-Zn ALLOY

ZHU Xianfang ZHANG Lide Institute of Solid State Physics , Academia Sinica , Hefei , China Research Assistant , Institute of Solid State Physics , Academia Sinica , Hefei , China

金属学报(英文版)

The characteristics of the low frequency internal friction and the modulus effect associated with the non-equilibrium spinodal pretransformation and the following discontinuous trans- formation was investigated in an as-quenched eutectiod Al-Zn alloy.It was observed that the loss of the stability in the lattice,which corresponded to the large-amplitude long-wavelength static concentration wave in the non-equilibrium spinodal pretransformation,did not induce any effect of localized soft modulus.Although there are two aging internal friction peaks in phase transformation which correspond to the appearance and disappearance of the coherency in spinodal pretransformation and the maximum of the interface area in the discontinuous transformation respectively,the effect of localized soft modulus did not take place yet.

关键词: spinodal pretransformation , null , null , null

CYCLIC OXIDATION BEHAVIOUR OF MICROCRYSTALLIZED CoCrAl COATING

WANG Fuhui LOU Hanyi WU Weitao Corrosion Science Laboratory , Institute of Corrosion and Protection of Metals , Academia Sinica , Shenyang , China Research Assistant , Institute of Corrosion and Protection of Metals , Academia Sinica , Shenyang 110015 , China

金属学报(英文版)

An investigation was carried out of the resistance to cyclic oxidation of the as-cast normal-grained Co-30Cr-5Al alloy substrate at 1000℃ in air together with its sputtered coating of microcrystallized CoCrAl alloy grains sized less than 0.5μm.Acoustie emissi on counts showed that the initially formed Al_2O_3 scale on the bare alloy substrate cracked and spalled severely off after only one or two cycles on cooling and then the worse protective layer of Cr_2O_3 and CoCr_2O_4 spinel occurred on surface.While such substrate coated with sputtered microcrystallized CoCrAl alloy film was not damaged under oxidation even through 100 cycles at 1000℃.In comparison with the normal-grained alloy,the microcrystallized al- loy,coating of similar constitution exhibite excellent resistance to oxide spalling on surface.

关键词: microcrystallized CoCrAl coating , null , null

KINETICS OF REACTION BETWEEN Cu_2S AND Cu_2O

LU Yuehua Kunming Institute of Precious Metals , Kunming , ChinaLIU Chunpeng Kunming Institute of Technology , Kunming , China Research Assistant , Laboratory No.1 , Kunming Institute of Precious Metals , Kunming 650031 , China

金属学报(英文版)

Reaction between Cu_2S and Cu_2O was investigated at 1150 to 1250℃.The reaction rate in- creases with the increase of surface area of Cu_2O grains and depends unobviously on temper- ature.At the suggestion of controlling step of reaction rate being oxygen diffusion through the liquid layer along reaction boundaries,two final kinetical equations would be made as follows: x=6.69×10~(-2)At for 0<α<0.74 and ln(l-α)=-A(9.83×10~(-2)t+1.76)for 0.74<α<1,where α is SO_2 evolved in time t and A is surface area of Cu_2O particles.

关键词: Cu_2O , null , null

INFLUENCE OF RESIDUAL STRESS AND SURFACE MORPHOLOGY ON FATIGUE PROPERTIES OF STEEL 60Mn

KANG Zengqiao GAI Xiuying LI Jiabao WANG Zhongguang State Key Laboratory for Fatigue and Fracture of Materials Institute of Metal Research , Academia Sinica , Shenyang , China Research Assistant , Institute of Metal Research , Academia Sinica , Shenyang 110015 , China

金属学报(英文版)

Influence of residual stress and surface morphology induced by shot-peening on fatigue behav- ior of a medium temperature tempered spring steel 60 Mn has been studied.The compressive residual stress induced in the near-surface region may improve fatigue limit from 930 to 1010 MPa,and the very high tensile residual stress in the interior may reduce it from 1010 to 940 MPa,whereas the severe surface damage may cause a drop-off of it from 1010 down to 800 MPa.Fatigue cracks initiated in such position where the equivalent Mises stress,including residual stress,exceeded the local strength of the material.The compressive residual stress, induced by shot-peening,may intensify the effect of crack closure,so as to decrease the crack growth rate.

关键词: shot-peening , null , null , null , null

Introduction to atmospheric corrosion research in China

Science and Technology of Advanced Materials

In this paper, we introduce the research on atmospheric corrosion in China. We describe the climate characteristics and the classification of atmospheric corrosivity across the whole country. We also describe the rusting evolution under simulated wet/dry cyclic conditions. (C) 2007 NIMS and Elsevier Ltd. All rights reserved.

关键词: atmospheric corrosion;corrosivity;rusting evolution;weathering steels;rust;mechanism;so2;o-3;no2

Recent developments in high temperature intermetallics research in China

Intermetallics

A comprehensive survey was made of various advances of intermetallics research in China. The investigation focussed on the fundamental research and materials development. Charge density distribution and site occupancy of alloying elements, environmental embrittlement and chemical reaction, interface structures and phase transformation at the atomic scale, nanocrystalline intermetallics and its thermal stability, superplastic behavior and anomalous yield strength peak are reviewed. Several Ti-Al and Ni-Al based alloys have been manufactured, and show good mechanical properties. Diverse components have been fabricated successfully. (C) 2000 Elsevier Science Ltd. All rights reserved.

关键词: aluminides, miscellaneous;hydrogen embrittlement;mechanical properties;at high temperatures;superplastic behavior;phase interfaces;grain-boundary fracture;in-situ composites;environmental;embrittlement;hydrogen embrittlement;ni3al;compression;alloys;co3ti;boron;feal

Development of Cast Superalloys for Gas Turbines in China

CHEN Rongzhang CHEN Wanhua Institute of Aeronautic Materials , Beijing 100095 , China.

材料科学技术（英）

As in other countries,significant achievements in the research of cast superalloys for many years have also been obtained in China.These results are important contribu- tion to the development of aero and land-based gas tur- bine engines.

关键词: cast superalloy , null

Key R&D activities for development of new types of wrought magnesium alloys in China

Transactions of Nonferrous Metals Society of China

Many researchers in China are actively engaged in the development of new types of wrought magnesium alloys with low cost or with high-performances and novel plastic processing technologies. The research activities are funded primarily through four government-supported programs: the Key Technologies R&D Program of China, the National Basic Research Program of China, the National High-tech R&D Program of China, and the National Natural Science Foundation of China. The key R&D activities for the development of new wrought magnesium alloys in China are reviewed, and typical properties of some new alloys are summarized. More attentions are paid to high-strength wrought magnesium alloys and high-plasticity wrought magnesium alloys. Some novel plastic processing technologies, emerging in recent years, which aim to control deformation texture and to improve plasticity and formability especially at room temperature, are also introduced.

关键词: wrought magnesium alloy;microstructure;properties;alloy designing;plastic deformation;research projects;y-zr alloys;mechanical-properties;mg-4y-4sm-0.5zr alloy;grain-refinement;rare-earth;microstructure;gd;phase;temperature;evolution

R&D STATUS ON INTERMETALLICS IN CHINA

CHEN Guoliang(State Key Laboratory for Advanced Metals and Materials University of Science and Technology Beijing Beijing 100083 , China)SHI Changxu (Academia Sinica , Beijing 100864 , China)

金属学报(英文版)

This paper briefiy introduces the R&D of intermetallics in China. R&D on intermetallics in a national scale in China began near ten years ago. The investigation in past years focused on the fundamental research and materials development. A significant progress has been made. Various components that made of Ti3Al Ni3Al, TiAl and Fe3Al have been successfully manufactured Some of them have been evaluted. It is expected that some intermetallic alloys will be produced in an industrial scale in the near future.

关键词: :intermetallic alloys , null , null , null

THE CHANGING ROLE OF THE NATIONAL LABORATORIES IN MATERIALS RESEARCH

WADSWORTH Jeffrey and FLUSS Michael(Chemistry and Materials Science Directorate , Lawrence Livermore National Laboratory , Livermore , CA 94551)

金属学报(英文版)

The role of the National Laboratories is summarized from the era of post World War II to the present time. The U.S. federal government policy for the National Laboratories and its influence on their materials science infrastructure is reviewed with respect to .determining overall research strategies, various initiatives to interact with industry (especially in recent years),building facilities that serve the nation, and developing leading edge research in the materials sciences. Despite reductions in support for research in the U.S. in recent years, and uncertainties regarding the specific policies for Research &Development (R&D) in the U.S., there are strong roles for materials research at the National Laboratories. These roles will be centered on the abilities of the National Laboratories to field multidisciplinary teams, the use of unique cutting edge facilities, a focus on areas of strength within each of the labs,increased teaming and partnerships, and the selection of motivated research areas. It is hoped that such teaming opportunities will include new alliances with China, in a manner similar, perhaps, to those recently achieved between the U.S. and other countries.

关键词: : U.S. Materials Science. U.S. National Laboratories and Facilities , null